Hi,
The OPC UA for Devices Companion Specification 1.01 wants the UIElementType as a subtype of BaseVariableType. In the UaModeler (1.5.386) it is not possible to create a subtype of BaseVariableType.
Is that only a limitation of the modeler or of the (.NET) SDK in general?
Cannot inherit from BaseVariableType in UaModeler
Moderator: uamodeler
-
- Hero Member
- Posts: 21
- Joined: 03 Mar 2017, 16:08
- Support Team
- Hero Member
- Posts: 3072
- Joined: 18 Mar 2011, 15:09
Re: Cannot inherit from BaseVariableType in UaModeler
Hello,
The OPC UA specification for BaseVariableType needs clarification. After the clarification of the specification we will or will not update UaModeler.
However you can load the DI model, it is shipped with UaModeler. If you load the model, the UIElementType is loaded as a subtype of BaseVariableType.
The OPC UA specification for BaseVariableType needs clarification. After the clarification of the specification we will or will not update UaModeler.
However you can load the DI model, it is shipped with UaModeler. If you load the model, the UIElementType is loaded as a subtype of BaseVariableType.
Best regards
Unified Automation Support Team
Unified Automation Support Team
-
- Hero Member
- Posts: 21
- Joined: 03 Mar 2017, 16:08
Re: Cannot inherit from BaseVariableType in UaModeler
Ahh, I didn't know there was this DI model... nice
So I understand that the Server can handle this.
Thanks!
So I understand that the Server can handle this.
Thanks!