Hi all,
I have a problem when trying to select the template set and output path from a project settings window.
When I go to the project settings the window shows a very condensed area where the template set and output path should appear. Unfortunately the template set and output path are not visible nor accessible .
I tried the following options, not solving the problem:
- Stretch the window. It only stretches horizontally. Stretching vertically is not possible.
- Re-install modeler. No changes.
- Change screen resolution. No changes.
Do you have any idea on how to possibly solve this issue?
Thanks!
Project settings window not allowing to select the template set and output path
Moderator: uamodeler
-
- Jr. Member
- Posts: 2
- Joined: 08 Feb 2022, 14:31
- Support Team
- Hero Member
- Posts: 3068
- Joined: 18 Mar 2011, 15:09
Re: Project settings window not allowing to select the template set and output path
Hi,
thank you for the report of the issue. However we can not reproduce. Eventhough the dialog window has no vertical resize, it has a vertical min-size instead and the layout of Qt works just fine.
You already tried the screen resolution, and it did not help, but maybe it is all about your magnification/zoom setting, you should configure it all back to 100%.
thank you for the report of the issue. However we can not reproduce. Eventhough the dialog window has no vertical resize, it has a vertical min-size instead and the layout of Qt works just fine.
You already tried the screen resolution, and it did not help, but maybe it is all about your magnification/zoom setting, you should configure it all back to 100%.
Best regards
Unified Automation Support Team
Unified Automation Support Team
-
- Jr. Member
- Posts: 2
- Joined: 08 Feb 2022, 14:31
Re: Project settings window not allowing to select the template set and output path
Thanks for your reply. Unfortunately changing the magnification/zoom setting does not solve the problem.
The artifact also disappears sometimes, but I haven't identified the cause.
The artifact also disappears sometimes, but I haven't identified the cause.