Hello,
I am using UAExpert 1.2.2 175
When the AutomaticReconnect feature is activated and if there was a subscription with MonitoredItems on the last connection
UAExpert is acting weirdly.
If there was i.e 1 subscription with 10MI, it will automatic reconnect and create 2 subscriptions, each one with the same 10MI but only 1 is displayed.
If there was i.e 2 subscriptions with 10MI each, it will auto reconnect and create 3 subscriptions, each one with the same 10MIs but only 2 are displayed.
....
Subscription and Automatic Reconnect
Moderator: uaexpert
-
- Hero Member
- Posts: 73
- Joined: 15 Feb 2012, 21:43
- Support Team
- Hero Member
- Posts: 3072
- Joined: 18 Mar 2011, 15:09
Re: Subscription and Automatic Reconnect
Hello,
Could you test with changed settings: General.SubscribeForModelChangeEvents switched off?
Best regards
Support Team
Could you test with changed settings: General.SubscribeForModelChangeEvents switched off?
Best regards
Support Team
-
- Hero Member
- Posts: 73
- Joined: 15 Feb 2012, 21:43
Re: Subscription and Automatic Reconnect
Forget to precise that SubscribeForModelChangeEvents has already been switched off.
When SubscribeForModelChangeEvents is true, this problem does not happen
It creates well 1 subscription for modelChangeEvents and one another for the previous subscription.
When SubscribeForModelChangeEvents is true, this problem does not happen
It creates well 1 subscription for modelChangeEvents and one another for the previous subscription.