"Cant connect to UA server"
Posted: 05 Nov 2021, 10:09
Hello,
i have a UA Gateway isntalled a while ago and i was reading data from a Nuntius OPC UA server and then sharing the data using OPC DA to a Wonderware Intouch sys
suddenly the UaGateway server wasnt able to start again
it says " Unable to start the COM service"
and when i try to open the configurator it says:
"the server you are trying to connect is not a Unified Automation Gateway"
any ideas ? its the exact same configuration than before
regards
i have a UA Gateway isntalled a while ago and i was reading data from a Nuntius OPC UA server and then sharing the data using OPC DA to a Wonderware Intouch sys
suddenly the UaGateway server wasnt able to start again
it says " Unable to start the COM service"
and when i try to open the configurator it says:
"the server you are trying to connect is not a Unified Automation Gateway"
any ideas ? its the exact same configuration than before
regards