Hello,
it seems that UaVariant::toExpandedNodeIdArray is always returning a OpcUa_BadOutOfRange error. I took a look at the source code and it seems that at line 8510 there is a check for the wrong datatype (OpcUaType_NodeId instead of OpcUaType_ExpandedNodeId). The same applies to UaVariant::toStatusCodeArray.
I'm using v1.3.2 (source code version).
If I'm correct, would it be possible to fix this in the next release?
Thank you,
Wim
Bug in uavariant.cpp?
Moderator: uasdkcpp
- Support Team
- Hero Member
- Posts: 3072
- Joined: 18 Mar 2011, 15:09
Re: Bug in uavariant.cpp?
Hi wim,
This issue was already fixed in October last year after release of version 1.3.2. The same issue was also fixed for toStatusCodeArray().
The fix will be contained in the next release 1.4.
Best Regards,
Unified Automation Support Team
This issue was already fixed in October last year after release of version 1.3.2. The same issue was also fixed for toStatusCodeArray().
The fix will be contained in the next release 1.4.
Best Regards,
Unified Automation Support Team
-
- Hero Member
- Posts: 24
- Joined: 13 Jul 2010, 15:20
Re: Bug in uavariant.cpp?
Thanks a lot!
Wim
Wim