Hi,
Is it possible to connect a Phoenix AXC1050 PLC (OPC UA Server) <ethernet> Sierra RV50 Modem <M2M Internet SD Card> directly to a Laptop with TIA Portal Professional Scada (OPC UA Client).
And is there something special which I should keep in mind while setting this up?
Thanks in advance! :)
OPC UA via M2M internet
Moderator: Support Team
- Support Team
- Hero Member
- Posts: 3068
- Joined: 18 Mar 2011, 15:09
Re: OPC UA via M2M internet
Hello,
OPC UA is based on TCP/IP, hence if you get a TCP/IP connection going, the OPC UA will work as well.
1) check if you can "ping" the other side machine.
2) check if you can "telnet" on port 4840
3) check if you can resolve hostnames on both sides
4) if you have your basic TCP/IP infrastructure running, OPC UA will run as well.
OPC UA is based on TCP/IP, hence if you get a TCP/IP connection going, the OPC UA will work as well.
1) check if you can "ping" the other side machine.
2) check if you can "telnet" on port 4840
3) check if you can resolve hostnames on both sides
4) if you have your basic TCP/IP infrastructure running, OPC UA will run as well.
Best regards
Unified Automation Support Team
Unified Automation Support Team
-
- Full Member
- Posts: 7
- Joined: 08 Sep 2021, 08:02
Re: OPC UA via M2M internet
Hello,
Thanks for the fast reaction!
Is it possible to go directly from TIA Portal to the AXC1050?
So that I use the IP of the modem(M2M SD-Card) or PLC in the OPC UA Client side of TIA Portal. (Which one should I use?)
And use the IP from the Laptop in the Phoenix UA Server software?
I am not sure if I am missing something..
I am new to data protocols so I am trying to figure out how I could get this working.
Thanks in advance!
Joost
Thanks for the fast reaction!
Is it possible to go directly from TIA Portal to the AXC1050?
So that I use the IP of the modem(M2M SD-Card) or PLC in the OPC UA Client side of TIA Portal. (Which one should I use?)
And use the IP from the Laptop in the Phoenix UA Server software?
I am not sure if I am missing something..
I am new to data protocols so I am trying to figure out how I could get this working.
Thanks in advance!
Joost
- Support Team
- Hero Member
- Posts: 3068
- Joined: 18 Mar 2011, 15:09
Re: OPC UA via M2M internet
Hello,
you "first" must do everything that is required to get a standard TCP/IP connection going.
As already described, OPC UA is based on TCP/IP. If you have two networks you most probably need routing. That is all basic network infrastructure configuration and has nothing to do with OPC UA.
you "first" must do everything that is required to get a standard TCP/IP connection going.
As already described, OPC UA is based on TCP/IP. If you have two networks you most probably need routing. That is all basic network infrastructure configuration and has nothing to do with OPC UA.
Best regards
Unified Automation Support Team
Unified Automation Support Team