PLC IP Address/OPC

General topics regarding OPC Foundation and communication technology in general.

Moderator: Support Team

Post Reply
einstein_g
Jr. Member
Jr. Member
Posts: 1
Joined: 19 Jul 2018, 21:21

PLC IP Address/OPC

Post by einstein_g »

I'm very new to PLCs and therefore, OPC. I have a Microogix 1000 (Allen Bradley) PLC, which I'd like to connect to an OPC server (KepserverEX) running on my computer.

To connect to the PLC, it obviously needs an IP address assigned.

Do I need to run a DHCP/BOOTP sofware on my PC? Do I need an Ethernet switch in between the PLC and the PC, or a crossover Ethernet cable to connect the PLC to the computer?

User avatar
Support Team
Hero Member
Hero Member
Posts: 2522
Joined: 18 Mar 2011, 15:09

Re: PLC IP Address/OPC

Post by Support Team »

Hello,

If you have no DNS service in your network, you should use the engineering tool of the PLC manufacturer and get the IP from there.

Some very old PLC have NICs that can not automatically cross, but in most cases a straight patch cable would be sufficient on a direct connection, because the NIC will cross automatically.

If you have switch in between you must use straight cables.
Best regards
Unified Automation Support Team

Post Reply